From: Nick Shah (nshah@xxxxxxxxxxxxxx)
Date: Wed May 15 2002 - 01:49:42 GMT-3
Thanks Jason. Much appreciated.
Nick
-----Original Message-----
From: Jason Sinclair <sinclairj@powertel.com.au>
To: 'Nick Shah' <nshah@connect.com.au>; ccielab@groupstudy.com
<ccielab@groupstudy.com>
Date: Wednesday, 15 May 2002 11:40
Subject: RE: bridging + ATM
>Nick,
>
>When you are using SNAP/LLC to transport data (as you are in this case) you
>are basically performing RFC 1483 encaps. Thus you do not need to specify
>the keywords protocol bridge under your interface. In fact this is a
default
>command in 12.2 (not sure about earlier releases). I believe that if you
>turn ATMinarp off then you will need to specify this.
>
>Cheers,
>
>Jason Sinclair CCIE #9100
>Manager, Network Control Centre
>POWERTEL
>Ground Level, 55 Clarence Street,
>SYDNEY NSW 2000
>AUSTRALIA
>office: + 61 2 8264 3820
>mobile: + 61 416 105 858
>* sinclairj@powertel.com.au
>
>
>
>
> -----Original Message-----
> From: Nick Shah [mailto:nshah@connect.com.au]
> Sent: Tuesday, 14 May 2002 11:37
> To: ccielab@groupstudy.com
> Subject: bridging + ATM
>
> Guys,
>
> Can someone help me here, I am doing a simple transparent
>bridging over ATM
> ... Now can someone tell me if I *have* to use "protocol
>bridge broad" under
> the PVC config or not...(ps. there are ethernet interfaces
>on both the
> routers which are a part of bridge group as well)
>
> R13..
>
> interface ATM0
> ip address 11.1.1.1 255.255.255.0
> pvc 0/112
> protocol ip 11.1.1.2 broadcast
> protocol ipx 14.000d.000d.000d broadcast
> oam-pvc manage
> encapsulation aal5snap
> !
> atm rate-queue 1 20
> no atm ilmi-keepalive
> sscop receive-window 14
> ipx network 14
> bridge-group 1
> end
>
> R14..
> interface ATM0
> ip address 11.1.1.2 255.255.255.0
> pvc 2/211
> protocol ip 11.1.1.1 broadcast
> protocol ipx 14.000c.000c.000c
> oam-pvc manage
> encapsulation aal5snap
> !
> atm rate-queue 1 20
> no atm ilmi-keepalive
> sscop receive-window 14
> ipx network 14
> bridge-group 1
> end
>
> Thanks in advance
> Nick
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:56 GMT-3