From: John Mistichelli (jmistichelli@xxxxxxxxx)
Date: Mon Apr 22 2002 - 23:44:06 GMT-3
The ports will have a prefix that begins with the switches prefix
"47.00000000003C0000A0000000."
For example:
Switch prefix: 47.00000000003C0000A0000000.XXXXXXXXXXXX.XX
Port 3.1 Prefix: 47.00000000003C0000A0000000.0031XXXXXXXX.XX
Port 3.2 Prefix: 47.00000000003C0000A0000000.0032XXXXXXXX.XX
This is just an example.
BTW. That model of switch defaults to that prefix. You will want to change
it if you plan to run PNNI.
John
7536
-----Original Message-----
From: Emmanuel Oppong [mailto:e-oppong@attbi.com]
Sent: Monday, April 22, 2002 10:31 PM
To: jmistichelli@yahoo.com
Cc: CCIE Mailist
Subject: RE: ATM SVC Config & 3Com-ATM-Switch
Thanks John,
I appreciate any help you can give me on this:
When I do "show atm ilmi-status" from ANY of the routers attahced to the
3com atm switch, it gives me the prefix 47.00000000003C0000A0000000. This
is what I am using for the full nsap addresses in my config. You're saying
I need to manually setup 2 prefixes, one for each port on the 3com atm
switch? Will this be any arbitrary prefix? What about the one already on
the switch? Does it mean I just need one more prefix? I will fool around
with switch and see if I can find where the prefixes are set.
Thanks again.
-----Original Message-----
From: John Mistichelli [mailto:jmistichelli@yahoo.com]
Sent: Monday, April 22, 2002 6:28 PM
To: Emmanuel Oppong
Cc: CCIE Mailist
Subject: RE: ATM SVC Config & 3Com-ATM-Switch
Are you sure the NSAP is correct? On that model switch it is necessary to
configure a prefix on each port to support SVCs if it is not configured for
NNI. You will need to use NSAP addresses that fall within the range
specified by a prefix. There will be a separate prefix per port.
On the switch: Login and select the CON menu. I believe its option 3. There
should be a section where you can add and verify your addresses per port. If
they are not setup you will have to do so.
Hope that helps
John
7536
-----Original Message-----
From: Emmanuel Oppong [mailto:e-oppong@attbi.com]
Sent: Monday, April 22, 2002 6:01 PM
To: jmistichelli@yahoo.com
Cc: CCIE Mailist
Subject: RE: ATM SVC Config & 3Com-ATM-Switch
I am using only one 3com atm switch. I add "atm pvc 2 0 16 ilmi" still not
working.
-----Original Message-----
From: John Mistichelli [mailto:jmistichelli@yahoo.com]
Sent: Monday, April 22, 2002 2:37 PM
To: Emmanuel Oppong
Cc: CCIE Mailist
Subject: RE: ATM SVC Config & 3Com-ATM-Switch
You will need a PVC 16 on each ATM interface.
example:
atm pvc 2 0 16 ilmi
John
7536
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:17 GMT-3