From: Jason Miller (jasmille@xxxxxxxxx)
Date: Fri Apr 19 2002 - 03:52:24 GMT-3
Joe,
You can change the path cost with interface command "ip ospf cost <cost value>"
. This can change what path you take by raising or lower cost but not the rout
e type from intra-area, inter-area, etc.
You can change the ospf distance of O, IA, External on the local router with ro
uter command "distance ospf ?". This can make one type or route preferred.
Jason
At 10:55 PM 4/18/2002 -0400, Joe Jia wrote:
>Hi,
>how to change the path at R2 to R1's ethernet0 from R2's serial0 to its
>ethernet 0?
>I have the case as following: R1,R2,R3 hub-spoke topology. R1 has ethernet0
>and searial 0 at area 0
>R2 has 64k serial0 and 10M ethernet interfaces, s0 in area0, ethernet0 in
>area1
>R3 has T1 serial0 and 10M ethernet interfaces, so in area 0 , ethernet 0 with
>R2's e0 in area 1
>
>I have the question, how can change R2's route to R1's ethernet0 from R2's
>serial0 to Ethernet0 because this way has a low cost?
>
>O , IA, E1, E2?
>
> 128.10.1.0/24
> ______(e0)
> |
> (area0)
> R1
> |
> (s0) 172.16.1.5/24
> (area0) / \ (area0)
> 64k / \ T1
> / \
> (s0) (s0)
> 172.16.1.6/24 | | 172.16.1.1/24
> R2 R3
> | (e0) | (e0)
> (area1)|________| (area1)
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:12 GMT-3