From: dwhitley@xxxxxxxxx
Date: Fri Apr 19 2002 - 10:07:07 GMT-3
Set the bandwidth on the serial links to reflect the real speeds, ospf will
then choose the correct lowest cost link.
-----Original Message-----
From: Joe Jia [mailto:ellenjjl@rogers.com]
Sent: Thursday, April 18, 2002 10:56 PM
To: ccielab@groupstudy.com
Subject: How to change route from O to IA in OSPF?
Hi,
how to change the path at R2 to R1's ethernet0 from R2's serial0 to its
ethernet 0?
I have the case as following: R1,R2,R3 hub-spoke topology. R1 has ethernet0
and searial 0 at area 0
R2 has 64k serial0 and 10M ethernet interfaces, s0 in area0, ethernet0 in
area1
R3 has T1 serial0 and 10M ethernet interfaces, so in area 0 , ethernet 0
with
R2's e0 in area 1
I have the question, how can change R2's route to R1's ethernet0 from R2's
serial0 to Ethernet0 because this way has a low cost?
O , IA, E1, E2?
128.10.1.0/24
______(e0)
|
(area0)
R1
|
(s0) 172.16.1.5/24
(area0) / \ (area0)
64k / \ T1
/ \
(s0) (s0)
172.16.1.6/24 | | 172.16.1.1/24
R2 R3
| (e0) | (e0)
(area1)|________| (area1)
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:13 GMT-3