From: Mingzhou Nie (mnie@xxxxxxxxx)
Date: Sat Apr 13 2002 - 02:14:38 GMT-3
This is interesting. I'm configuring dialer watch on dialer profile.
2503a is calling 4500a. If I enter "dialer load-threshold 1 either" in
interface dialer0, even after serial interfaces come back, r1 keeps
bringing up isdn link. If I took it out, isdn link becomes idle at next
idle time out. Why is that?
Mingzhou Nie
1w6d: %DIALER-6-UNBIND: Interface BR0:1 unbound from profile Di0
1w6d: %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 94724811
, call ls
1w6d: %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
1w6d: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed
state to n
1w6d: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
1w6d: %DIALER-6-BIND: Interface BR0:1 bound to profile Di0
1w6d: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed
state to p
1w6d: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 94724811
1w6d: %DIALER-6-UNBIND: Interface BR0:2 unbound from profile Di0
1w6d: %ISDN-6-DISCONNECT: Interface BRI0:2 disconnected from 94724811
, call ls
1w6d: %LINK-3-UPDOWN: Interface BRI0:2, changed state to down
1w6d: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2, changed
state to n
1w6d: %LINK-3-UPDOWN: Interface BRI0:2, changed state to up
1w6d: %DIALER-6-BIND: Interface BR0:2 bound to profile Di0
1w6d: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2, changed
state to p
1w6d: %ISDN-6-CONNECT: Interface BRI0:2 is now connected to 94724811
=====
- | |
:|||: :|||:
:|||||||: :|||||||:
.:|||||||||||:.:|||||||||||:.
C i s c o S y s t e m s
www.cisco.com/tac
Empowering the Internet Generation
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:07 GMT-3