From: Jason (jgraun@xxxxxxxxx)
Date: Wed Apr 10 2002 - 11:41:39 GMT-3
You cannot, if you do an area 0 range command you will see this in the
routing table of the router in which you issued that command, however
that LSA will never get propagated to other OSPF routers. Use tunnels
or secondary addresses to solve classless-classfull problems.
Jason
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Khan Munib
Sent: Wednesday, April 10, 2002 9:14 AM
To: 'ccielab@groupstudy.com'
Subject: ospf area range command question???
Can anyone tell me what command to use to get the network summarized by
an
area range command for area 0 to be installed into other area 0 routers.
I have the following scenario.....
R2 (Area 0) has a virtual link to R6 (area 60). R6 is also
redistributing
OSPF into IGRP. In order to get the area 0 network into the igrp
routing
table I must summarise it using the area range command. However, R6
dose
not install the summarised route into it's routing table as (by my
reckoning) it believes it is hanging off Area 0 due to the Virtual
link.
See diagram below for clarity......
Area 0 ---------- R2----------F/R--Area
5--------------R6------------IGRP----------
Just to add, When I do an area 5 range command on R2 to summarise the
F/R
cloud, it gets installed on R6(Even though R6 is directly connected to
Area
5) and is redistributed to IGRP, so why not the same case with area 0.
Thanx.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:04 GMT-3