From: Khan Munib (Munib.Khan@xxxxxxxxxxxxxxxxxxxx)
Date: Wed Apr 10 2002 - 11:13:32 GMT-3
Can anyone tell me what command to use to get the network summarized by an
area range command for area 0 to be installed into other area 0 routers.
I have the following scenario.....
R2 (Area 0) has a virtual link to R6 (area 60). R6 is also redistributing
OSPF into IGRP. In order to get the area 0 network into the igrp routing
table I must summarise it using the area range command. However, R6 dose
not install the summarised route into it's routing table as (by my
reckoning) it believes it is hanging off Area 0 due to the Virtual link.
See diagram below for clarity......
Area 0 ---------- R2----------F/R--Area
5--------------R6------------IGRP----------
Just to add, When I do an area 5 range command on R2 to summarise the F/R
cloud, it gets installed on R6(Even though R6 is directly connected to Area
5) and is redistributed to IGRP, so why not the same case with area 0.
Thanx.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:03 GMT-3