From: Narvaez, Pablo (Pablo.Narvaez@xxxxxxxxxxxxx)
Date: Fri Apr 05 2002 - 16:48:21 GMT-3
I think both of them are correct, the point is on which router they will allow
you to configure that ... It basically depends on the statement .... "configure
the following on router1 or router2"
I would like to hear someelses opinion ....
cheers,
hockito
-----Original Message-----
From: Williams, Glenn [mailto:WILLIAMSG@PANASONIC.COM]
Sent: Viernes, 05 de Abril de 2002 01:13 p.m.
To: 'ccielab@groupstudy.com'
Subject: access-expression vs. lsap output-list
If given a choice in a DLSW scenario where the task is to prevent a DLSW
peer R1 from accessing any say netbios hosts on R2 Tokenring, which would
you choose?
R1
access-list 200 deny 0xf0f0 0x0101
access-list 200 permit 0x0000 0xffff
dlsw remote-peer 0 tcp 2.2.2.2 lsap-output-list 200
OR
R2
access-list 200 deny 0xf0f0 0x0101
access-list 200 permit 0x0000 0xffff
int tok 0
access-expression in lsap(200)
hopefully my syntax is correct.
GW
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:56 GMT-3