From: Greg Parrish (gparrish@xxxxxxxxx)
Date: Fri Apr 05 2002 - 16:45:28 GMT-3
Try and telnet to the switch to make sure it is up and you have a prompt and
then work on your laptop com port config, hyperterm config, cable problem until
you get to the prompt on the console also. Also check the 'show system' and be
sure baud rate has not been changed from the default if you are expecting 9600.
Greg
Scott Morris wrote:
> Depends on what type of cable you have in it. :)
>
> The 6500's can do either straight-through or rolled. There's a little hole
> next to the port, you can use a paper clip to select which method is being
> used.
>
> I am assuming that this is what you mean when you say you don't see anything
> while booting (or does it miraculously appear after it's booted?)
>
> Scott
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Ma Gang
> Sent: Friday, April 05, 2002 12:54 AM
> To: ccielab@groupstudy.com
> Subject: Catalyst 6506 problem
>
> Dear All,
>
> We meet a Catalyst 6506 problem here. The symptom is the CONSOLE shows
> nothing when the 6506 is booting. The console is configed as 9600/8/N/1. No
> matter how I press the keyboard, it still shows nothing.
>
> Anyone here met this problem before, and how to solve it?
>
> Thanks in advance.
>
> Regards
>
> Matthew Ma
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:56 GMT-3