From: Louis Young (tonyblair@xxxxxxxxx)
Date: Mon Mar 25 2002 - 07:29:35 GMT-3
I know that ,so ospf up or not is not an issue here, what I mean is why can't I
enter routing protocol config mode???
----- Original Message -----
From: "Nelson Salvatorelli" <nsalvato@cisco.com>
To: "Louis Young" <tonyblair@etang.com>; <ccielab@groupstudy.com>
Sent: Monday, March 25, 2002 6:12 PM
Subject: RE: Weird Symptom: can not enter (config-router)# mode in ISIS and OSP
F ,why???
> You can't configure OSPF without having an "IP configured" interface and
> the interface should be up/up...
>
> Off topic, this happens also in MPLS scenarios where you don't have
> configured an interface with the 'ip vrf forwarding <vrf_name>'
>
> Hope it helps!
>
> Cheers,
>
> -nelson
>
>
> > -----Original Message-----
> > From: Louis Young [mailto:tonyblair@etang.com]
> > Sent: 25 March 2002 09:38
> > To: ccielab@groupstudy.com
> > Subject: Weird Symptom: can not enter (config-router)# mode
> > in ISIS and OSPF ,why???
> >
> >
> > Dear all,
> > I got the following phenomena during lab routers, it
> > is a 2610,pls help me out!
> >
> > Router(config)#
> > Router(config)#router ospf 10
> > Router(config)#
> > 00:18:17: %OSPF-4-NORTRID: OSPF process 10 cannot start.
> > There must be at least one "up" IP interface, for OSPF to use
> > as router ID Router(config)#router isis Router(config)#net
> > 01.2222.2222.2222.00
> > ^
> > % Invalid input detected at '^' marker.
> >
> > Router(config)#^Z
> > Router#sh ver
> > 00:18:54: %SYS-5-CONFIG_I: Configured from console by console
> > Cisco Internetwork Operating System Software
> > IOS (tm) C2600 Software (C2600-IS-M), Version 12.1(10),
> > RELEASE SOFTWARE (fc1) Copyright (c) 1986-2001 by cisco
> > Systems, Inc. Compiled Mon 06-Aug-01 23:48 by kellythw Image
> > text-base: 0x80008088, data-base: 0x80CD6E7C
> >
> > ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
> >
> > Router uptime is 18 minutes
> > System returned to ROM by reload
> > System image file is "flash:c2600-is-mz.121-10.bin"
> >
> > cisco 2610 (MPC860) processor (revision 0x203) with
> > 26624K/6144K bytes of memory. Processor board ID JAD05270J95
> > (1358695238) M860 processor: part number 0, mask 49 Bridging
> > software. X.25 software, Version 3.0.0. 1 Ethernet/IEEE 802.3
> > interface(s) 1 Serial network interface(s) 32K bytes of
> > non-volatile configuration memory. 8192K bytes of processor
> > board System flash (Read/Write)
> >
> > Configuration register is 0x2102
> >
> >
> > Thanks in advance.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:21 GMT-3