RE: SR/TLB issue

From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Thu Mar 21 2002 - 01:51:14 GMT-3

   
Jack,

Please post your configs of your end devices. Also do a show source and a
show rif on R2.

Cheers,

Jason Sinclair
Manager, Network Support Group
POWERTEL
Ground Level, 55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
* sinclairj@powertel.com.au

                -----Original Message-----
                From: Jack S [mailto:prospectccie@yahoo.com]
                Sent: Thursday, 21 March 2002 12:52
                To: ccielab@groupstudy.com
                Subject: SR/TLB issue

                Hi,

                I am trying to do SR/TLB in a simple 3 router setup -

                 .1 .2
                R1----eth---R2----to----R3
                    netw: 192.168.1.0/24

                I configured R1 & R3's interfaces with ip addresses
                and bridged everything on R2 using SR/TLB. But, for
                some reason, R1 couldn't ping R3. Here are the configs
                on R2-

                source-bridge ring-group 1000
                source-bridge transparent 1000 1111 1 1
                !
                interface Ethernet0/1
                 no ip address
                 no ip route-cache
                 bridge-group 1
                !
                interface TokenRing3/0
                 no ip address
                 no ip route-cache
                 ring-speed 16
                 multiring all
                 source-bridge 5 1 1000
                !
                bridge 1 protocol ieee
                bridge 1 bitswap-layer3-addresses

                Am I missing something here? Any insights/ideas are
                appreciated. Thanks in advance.

                Regards,
                Jack

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:15 GMT-3