From: steven.j.nelson@xxxxxx
Date: Mon Mar 11 2002 - 13:21:25 GMT-3
www.cisco.com/warp/public/701/45.html
-----Original Message-----
From: Nicolai Gersbo Solling [mailto:nicolai@cisco.com]
Sent: 11 March 2002 15:32
To: CCIE
Subject: verifying DLSW+
Hi there!
I am trying to figure out a good way of verifying that my DLSW setup.
What I have is this!
|
MACHINE1 |----R1-----------DLSW--------R2----RING2
| |
|
RING 1
The DLSW is up and running and I configured the R1 SR/TLB like this:
R1
source-bridge ring-group 5
source-bridge transparent 5 70 1 3
Int Eth0
bridge-group 3
interface Virtual-TokenRing1
no ip address
ring-speed 16
source-bridge 20 1 5
bridge 3 protocol ieee
R2
source-bridge ring-group 5
interface Virtual-TokenRing1
no ip address
ring-speed 16
source-bridge 30 1 5
I tried connecting a Win95 WS running netbios on the Ethernet0 on R1, and I
thought I would then see this machine name under reachebility on R2, but it
does not show - If I do an icanreach it of course shows up, but somehow I do
not think this verifies my work well enough...
If some DLSW+ guru out there could just read through my config and say if I
am totally wrong here I would appreciate it!
Also...if someone has a super hot document on DLSW+ and bridging in general
I would love to see it - Somehow I do not think DLSW is that hard, it is
just hard to get to the right information...
Nic
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:00 GMT-3