From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Fri Mar 08 2002 - 00:50:25 GMT-3
All,
This is normal for 2500's as they use the flash helper to load new IOS. You
need to just do copy tftp flash and it will prompt you from their and the
FLH will reload the router in read/write mode and upload the file.
Cheers,
Jason Sinclair
Manager, Network Support Group
POWERTEL
Ground Level, 55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
* sinclairj@powertel.com.au
-----Original Message-----
From: Narvaez, Pablo [mailto:Pablo.Narvaez@getronics.com]
Sent: Friday, 8 March 2002 10:00
To: Ludwig Morales; ccielab@groupstudy.com
Subject: RE: read only Flash
Change the configuration register value to have the router
boot from BOOT ... in this mode, the flash becomes Read/Write.
You can use the conf reg value 0x1.
router(config)# config-register 0x1
router# reload
router<(boot)># sh ver
.
.
.
16384K bytes of processor board System flash (Read/Write)
Upgrade the router, change back the conf reg value to
0x2102, reload the router and that's it.
Cheers,
hockito
-----Original Message-----
From: Ludwig Morales [mailto:morales_l@hotmail.com]
Sent: Jueves, 07 de Marzo de 2002 05:38 p.m.
To: ccielab@groupstudy.com
Subject: read only Flash
Pie Chartshi everybody,
one of my routers flash states to be "read only" how do i
change this so
that i can erase it and load another IOS
cisco 2500 (68030) processor (revision L) with 14336K/2048K
bytes of memory.
Processor board ID 08319120, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Token Ring/IEEE 802.5 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
regards,
Ludwig
[GroupStudy.com removed an attachment of type text/x-vcard
which had a name of Ludwig A. Morales.vcf]
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:56 GMT-3