From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Fri Mar 08 2002 - 00:50:47 GMT-3
Also - the flash helper will prompt you for erase at the time.
Jason Sinclair
Manager, Network Support Group
POWERTEL
Ground Level, 55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
* sinclairj@powertel.com.au
-----Original Message-----
From: Narvaez, Pablo [mailto:Pablo.Narvaez@getronics.com]
Sent: Friday, 8 March 2002 10:00
To: Ludwig Morales; ccielab@groupstudy.com
Subject: RE: read only Flash
Change the configuration register value to have the router
boot from BOOT ... in this mode, the flash becomes Read/Write.
You can use the conf reg value 0x1.
router(config)# config-register 0x1
router# reload
router<(boot)># sh ver
.
.
.
16384K bytes of processor board System flash (Read/Write)
Upgrade the router, change back the conf reg value to
0x2102, reload the router and that's it.
Cheers,
hockito
-----Original Message-----
From: Ludwig Morales [mailto:morales_l@hotmail.com]
Sent: Jueves, 07 de Marzo de 2002 05:38 p.m.
To: ccielab@groupstudy.com
Subject: read only Flash
Pie Chartshi everybody,
one of my routers flash states to be "read only" how do i
change this so
that i can erase it and load another IOS
cisco 2500 (68030) processor (revision L) with 14336K/2048K
bytes of memory.
Processor board ID 08319120, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Token Ring/IEEE 802.5 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
regards,
Ludwig
[GroupStudy.com removed an attachment of type text/x-vcard
which had a name of Ludwig A. Morales.vcf]
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:56 GMT-3