From: Gregg Malcolm (greggm@xxxxxxxxxxxxx)
Date: Sun Mar 03 2002 - 20:04:42 GMT-3
I was under the impression that POD was only useable between peer groups.
Since a router can only be a member of 1 peer group (B in this case), I
didn't think POD would work in this scenario.
I'm going to try to recreate in my lab. Really good question as there is
little info on CCO regarding this exact situation.
----- Original Message -----
From: "Bob Sinclair" <bsin@erols.com>
To: "John Mistichelli" <jmistichelli@yahoo.com>
Cc: <ccielab@groupstudy.com>
Sent: Sunday, March 03, 2002 1:31 PM
Subject: Re: DLSW: Circuits with no remote peer statements?
> I have used POD to get B to set up a circuit between A and C. In that
scenario, you do not require a full mesh. But in every example I have seen,
A and C point to B with remote peer statements that make them part of the
group. Does POD work when the spokes have no (nada, none) remote peer
statements at all?
>
>
> ----- Original Message -----
> From: "John Mistichelli" <jmistichelli@yahoo.com>
> To: "Bob Sinclair" <bsin@erols.com>; <ccielab@groupstudy.com>
> Sent: Sunday, March 03, 2002 3:50 PM
> Subject: RE: DLSW: Circuits with no remote peer statements?
>
>
> > Yes, its called Peer-on-demand.
> >
> > It is on by default. All you have to do is configure the router with the
> > peer statements as a border peer.
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> > Bob Sinclair
> > Sent: Sunday, March 03, 2002 2:03 PM
> > To: ccielab@groupstudy.com
> > Subject: DLSW: Circuits with no remote peer statements?
> >
> >
> > DLSW Gurus,
> >
> > Is it possible to have a circuit set up between two routers if neither
of
> > them has any remote peer statements? Suppose you have routers A, B and
C
> > runnng DLSW. B has remote peer statements to both A and C. A and C are
> > promiscuous. Absolutely no peer statements on A or C. Can a device
> > attached to A connect to a device attached to C? Would static resources
> > help?
> >
> > Thanks. Just Wondering.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:51 GMT-3