From: Williams, Glenn (WILLIAMSG@xxxxxxxxxxxxx)
Date: Fri Feb 22 2002 - 16:25:58 GMT-3
Can you use the router-id command in ospf router configuration mode?
GW
-----Original Message-----
From: Przemyslaw Karwasiecki [mailto:karwas@ifxcorp.com]
Sent: Friday, February 22, 2002 1:12 PM
To: ccielab@groupstudy.com
Subject: OSPF virtual links
Group,
Simple question:
Is it possible to create virtual link (connect virtual areas)
using interface address instead of OSPF router ID?
Cisco documentation says:
area <area-id> virtual-link <router-id>
Obviously, using RID is better for stability reasons,
but one can imagine hyphothetical situation when OSPF RID
is not in routing table, so it would not be reachable for
virtual-link.
Comments?
Thanks,
Przemek
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:30 GMT-3