From: Michael C. Popovich (mpopovich@xxxxxxxxxx)
Date: Sat Feb 09 2002 - 19:04:40 GMT-3
After reading all the lab sections I was wrong about OSPF being the only
IGP. There is others being configured in section V.
-----Original Message-----
From: Carl Phelan [mailto:carlphelan@hotmail.com]
Sent: Saturday, February 09, 2002 3:25 PM
To: ccielab@groupstudy.com
Subject: Solie - Darth Reid - Lab 2
Hi All,
In the 'Darth Reid' lab in Solie's CCIE practical Studies book, the
directions
are as follows:
'R1, R3 and R4 should share the same subnet. Configure OSPF Area 0
between
the routers; do not change the 'ip ospf network' type when configuring
OSPF'.
This to me says place these 3 routers in to OSPF area 0, right? Wrong!
The
solution includes R2 in area 0 as well - although it is a member router
of the
frame, the directions as I read them imply that only the 3 routers
stated are
part of Area 0. I know that the instructions in the real lab itself
can be
ambiguous and are open to interpretation but am I being unreasonable in
my
interpretation of this instruction? Could the real lab possibly be as
ambiguous as this? I would appreciate your interpretation of this
instruction.
Many thanks,
Carl
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:17 GMT-3