From: Cael Phelan (carlphelan@xxxxxxxxxxx)
Date: Wed Feb 06 2002 - 09:55:29 GMT-3
Hi All,
In this first lab of the book 'CCIE Practical Studies', the directions clearly
state:
'Do not use the 'ip ospf network' command when configuring OSPF'
yet the solution as provided by Cisco press uses this command everywhere. Yes
indeed, 'ip ospf network non-broadcast' will give a hello time of 60 seconds
but without using this command, you would have to enter 'ip ospf
hello-interval 60' on the serial interface of R3 as directed and on the other
routers R1 and R2 to peer. The 'ip ospf network' command is even used on the
LAN interfaces according to the solution Am I missing something here and are
the remaining four labs' solutions as bad?
Many thanks,
Carl
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:13 GMT-3