From: Steven Weber (itweber@xxxxxxxxxxxxx)
Date: Wed Feb 06 2002 - 11:03:58 GMT-3
non-broadcast is the default
----- Original Message -----
From: "Cael Phelan" <carlphelan@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Wednesday, February 06, 2002 7:55 AM
Subject: Solie - Skynet Lab 1
> Hi All,
>
> In this first lab of the book 'CCIE Practical Studies', the directions
clearly
> state:
> 'Do not use the 'ip ospf network' command when configuring OSPF'
> yet the solution as provided by Cisco press uses this command everywhere.
Yes
> indeed, 'ip ospf network non-broadcast' will give a hello time of 60
seconds
> but without using this command, you would have to enter 'ip ospf
> hello-interval 60' on the serial interface of R3 as directed and on the
other
> routers R1 and R2 to peer. The 'ip ospf network' command is even used on
the
> LAN interfaces according to the solution Am I missing something here and
are
> the remaining four labs' solutions as bad?
>
> Many thanks,
>
> Carl
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:13 GMT-3