From: kenairs (kenairs@xxxxxxxxxxx)
Date: Wed Feb 06 2002 - 04:54:20 GMT-3
I can ping the spokes from R1. But if i run IPX eigrp , then on the spokes i
should see the different IPX network via IPX eigrp. But i just can get this
right.
----- Original Message -----
From: Mannan Venkatesan <mv_lab@hotmail.com>
To: kenairs <kenairs@hotmail.com>; <ccielab@groupstudy.com>
Sent: Wednesday, February 06, 2002 3:57 PM
Subject: Re: IPX eigrp over FR
> Normally, you would have problem with 'ipx eigrp nei' because of frame
> mappings. But you can ping the remote, then it should be ok. Configs and
'sh
> fram map' can help.
>
> Mannan
>
> ----- Original Message -----
> From: "kenairs" <kenairs@hotmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Wednesday, February 06, 2002 2:08 AM
> Subject: IPX eigrp over FR
>
>
> > Hi,
> > Below is my setup..
> >
> > R1
> > | |
> > | |
> > | |
> > R2 R3
> >
> >
> > R1 , R2 and R3 are connected over FR . R1 is the hub and R2 and R3 is
the
> > spoke.
> > I configured R1 with 2 p-t-p subinterfaces and R2 and R3 with physical
> > interface.
> >
> > R1 - R2 is one subnet. R1 and R3 is one subnet.
> >
> > I then disable IPX RIP and enable IPX eigrp over the FR.
> > ipx
> > But i can seem to form any ipx eigrp nei between R1-R2 and R1-R3. I try
to
> > ping ipx from R1 to R2 and R1 to R3 and both are successfully.
> >
> > Please help.
> > Tks
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:12 GMT-3