From: Bauer, Rick (BAUERR@xxxxxxxxxxx)
Date: Fri Jan 04 2002 - 10:44:29 GMT-3
56K uses pins 1, 2, 7, and 8 and T1 uses 1, 2, 4, and 5 They also use
different framing and modulation. So it will not work.
If you have two 56K CSUs you can use a Cisco console cable to cross connect
them since it is a rollover.
-----Original Message-----
From: George Hansen [mailto:HansenG@radiological.com]
Sent: Thursday, January 03, 2002 3:44 PM
To: ccielab@groupstudy.com
Cc: jhconsulting2001.yahoo.INTERNET@yahoo.com
Subject: Re: OT: back-to-back with SM25-56k4 and wic-1dsu-t1 cards
Here's a link describing the WIC-1DSU-56K4. I couldn't find a similar page
for the SM25-56K4, but I'm assuming they handle the 56K CSU/DSU part in a
similar fashion. I wonder if you made a special crossover cable (the pinouts
are different from T1) and set the T1 service-module for only 1 56K channel
if it would work? Probably not, as the T1 side will still be looking for
it's line code information just to set the one channel.
http://www.cisco.com/warp/public/107/hw_56k_wic.shtml
George
>>> "Tony Hanks" <jhconsulting2001@yahoo.com> 01/03/02 09:33AM >>>
To all,
I have a 2524 router w/ a sm25-56k4 card. I am trying to connect this
module with a 2621 router w/ a wic-1dsu-t1 card by using a T-1 cross-over
cable, but haven't figured out how to do it or whether this is possible. I
know the cable is good because I used it for wic-1dsu-t1 to wic-1dsu-t1
connection before. Can any one help??? A sample config would also be
greatly appreciated. Thanks in advance.
Regards,
Tony Hanks
J & H Consulting, Inc.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:15 GMT-3