From: George Hansen (HansenG@xxxxxxxxxxxxxxxx)
Date: Thu Jan 03 2002 - 17:43:53 GMT-3
Here's a link describing the WIC-1DSU-56K4. I couldn't find a similar page for
the SM25-56K4, but I'm assuming they handle the 56K CSU/DSU part in a similar f
ashion. I wonder if you made a special crossover cable (the pinouts are differe
nt from T1) and set the T1 service-module for only 1 56K channel if it would wo
rk? Probably not, as the T1 side will still be looking for it's line code infor
mation just to set the one channel.
http://www.cisco.com/warp/public/107/hw_56k_wic.shtml
George
>>> "Tony Hanks" <jhconsulting2001@yahoo.com> 01/03/02 09:33AM >>>
To all,
I have a 2524 router w/ a sm25-56k4 card. I am trying to connect this
module with a 2621 router w/ a wic-1dsu-t1 card by using a T-1 cross-over
cable, but haven't figured out how to do it or whether this is possible. I
know the cable is good because I used it for wic-1dsu-t1 to wic-1dsu-t1
connection before. Can any one help??? A sample config would also be
greatly appreciated. Thanks in advance.
Regards,
Tony Hanks
J & H Consulting, Inc.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:15 GMT-3