From: Palacios, Gonzalo (gpalacios@xxxxxxxxxxxxxxxxx)
Date: Wed Jan 02 2002 - 13:24:22 GMT-3
try :
asyn default routing (as opposed to dynamic)
It is very useful to use those aux's as serials if you are lacking
cisco-blue-cables.
-----Original Message-----
From: tobccie2002@yahoo.com [mailto:tobccie2002@yahoo.com]
Sent: Tuesday, January 01, 2002 1:00 PM
To: ccielab@groupstudy.com
Subject: aux with "No Hellos"?????
hi,dear all,
firstly,happy new year 2 u all!!! :-)
when i configured 2 routers(2500) with aux which r taken as serial lines,i
met some problem :
R4#sh ip ospf int asy 1
Async1 is up, line protocol is up
Internet Address 139.1.1.4/29, Area 1
Process ID 1, Router ID 139.4.4.4, Network Type POINT_TO_POINT, Cost:
11111
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
No Hellos (Passive interface) ---------------------PAY ATTENTION PLZ!!!
Index 1/5, flood queue length 0
Next 0x0(0)/0x0(0)
Last flood scan length is 0, maximum is 0
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 0, Adjacent neighbor count is 0
Suppress hello for 0 neighbor(s)
---------------------------------------
so,of course ,they CAN'T be neighbors.|
---------------------------------------
and the configuration:
......
interface Async1
ip address 139.1.1.4 255.255.255.248
encapsulation ppp
async dynamic routing
async mode dedicated
.........
line aux 0
modem InOut
transport input all
speed 38400
flowcontrol hardware
yes,it DOES work when i "PING",and i can c each other with "sh cdp nei"
btw,it DOESN'T work in "eigrp" also!!! ('cauze passive hello,i think)
what's wrong,and how can i correct it?
thank u all!
tobccie2002
tobccie2002@yahoo.com
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:14 GMT-3