From: Ravi (s_ravichandran@xxxxxxxxxxx)
Date: Sat Dec 29 2001 - 10:18:30 GMT-3
I found the following on Cisco CCO about dialer watch.
Note: It is recommenced that you use Cisco IOS Software Release12.1(7) or
higher, which includes fixes for IOS bugs that affect dialer watch.
http://www.cisco.com/warp/public/123/backup-main.html#second
Regards,
Ravi
----- Original Message -----
From: "Marc Russell" <mrussell@ccbootcamp.com>
To: <sdecker@bellsouth.net>; <ccielab@groupstudy.com>
Sent: Friday, December 21, 2001 11:27 PM
Subject: RE: LS1010/router integration
> Do you have at least the basic config below on your router?
>
> interface ATM0/0
> no ip address
> no ip directed-broadcast
> atm pvc 1 0 5 qsaal
> atm pvc 2 0 16 ilmi
> no atm ilmi-keepalive
> no shut
>
>
> Marc Russell
> www.ccbootcamp.com
>
>
> -----Original Message-----
> From: sdecker@bellsouth.net
> To: ccielab@groupstudy.com
> Sent: 12/21/01 6:03 PM
> Subject: LS1010/router integration
>
> Hi list:
>
> I'm fortunate enough to have just procured an LS1010 for my lab. It's
> my understanding that its default configuration should allow auto-config
> to occur. However, when I go to my connected router interface and set
> it for auto-config, all interfaces show up/up but 'show atm int' on the
> LS1010 says 'waiting for response from peer'. Am I doing something
> wrong? Just another one of many questions from an ATM newbie. ;-)
>
> TIA,
>
> Scott
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:49 GMT-3