From: Young Brown (lybrown@xxxxxxxxx)
Date: Sat Dec 15 2001 - 18:53:57 GMT-3
Annu,
1. %SYS-4-CONFIG_NEWER: Configuration from version [dec].[dec] may not be
correctly understood
The software has detected that the configuration saved in memory was written
by a newer version of software. There might be commands saved in memory that
are not implemented by the older software version.
Recommended Action: Examine all the messages printed while the router was
booting. For each message about an unknown command, determine if that
feature is required. If any of the unknown command features is required,
upgrade to a newer version of software that supports the required feature.
This result was obtained from:
http://www.cisco.com/cgi-bin/Support/Errordecoder/home.pl
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Annu
Sent: Saturday, December 15, 2001 1:34 PM
To: ccielab@groupstudy.com
Subject: Cisco 2514 Upgrade Problem
Group,
I am trying to upgrade a Cisco 2514 from 12.0 code to
12.1 as the router has been rebooting itself every
other hour and also reboots when policy routing or
Offset list is configured.
I get the following error irrespective of how i
upgrade - from Boot mode or ROM monitor mode ? Is the
FLASH corrupted or what is the remedy to this ?
-------
>b c2500-js56i-l.120-5.bin 192.1.1.5
%SYS-4-CONFIG_NEWER: Configurations from version 12.0
may not be correctly understood.
Loading c2500-js56i-l.120-5.bin .from 192.1.1.5 (via
Ethernet0): !!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!Parity (control reg=0x8318)
Error, address: 0xE022D0 at 0x1098CE4 (PC)
System Bootstrap, Version 11.0(10c), SOFTWARE
Copyright (c) 1986-1996 by cisco Systems
2500 processor with 14336 Kbytes of main memory
%SYS-4-CONFIG_NEWER: Configurations from version 12.0
may not be correctly under
stood.
Thanks for ut ime and answers.
Annu.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:43 GMT-3