From: Williams, Glenn (WILLIAMSG@xxxxxxxxxxxxx)
Date: Fri Nov 30 2001 - 10:16:35 GMT-3
Thanks, but this is not the issue. I can't see any difference in my setup
and the lab answers except they were using an ip ospf broadcast network on
the point to point R1-R2.
GW
-----Original Message-----
From: routerkid [mailto:routerkid@adelphia.net]
Sent: Friday, November 30, 2001 6:55 AM
To: Williams, Glenn
Subject: Re: Lab 4 vlinks
I have seen this a number of times.. Make sure you are using the RID of the
other router in your virtual-link statements. You can identify the RIF by
doing sh ip ospf prot on each router to gather that information. Then use
the RID of the remote router when you configure the virtual link...
HTH...
----- Original Message -----
From: Williams, Glenn <WILLIAMSG@PANASONIC.COM>
To: <ccielab@groupstudy.com>
Sent: Thursday, November 29, 2001 10:00 PM
Subject: Lab 4 vlinks
> Hi,
>
> Has anyone had the problem where this message is received on lab 4, R2
>
> 00:22:07: %OSPF-4-ERRRCV: Received invalid packet: mismatch area ID, from
> backbone area must be virtual-link but not found from 10.10.1.5, Serial0
>
> 00:22:16: %OSPF-4-ERRRCV: Received invalid packet: mismatch area ID, from
> backbone area must be virtual-link but not found from 10.10.1.3, Serial0
>
> Area 5 is configured as a v link between R1 and R2 to the OSPF router ids.
> I have done v links successfully in the past.
>
> The problem goes away when I issue this command on R2 only:
>
> R2(config-router)#area 5 virtual-link 11.1.1.5
>
> R2(config-router)#area 5 virtual-link 10.33.1.65
>
> Did I miss something big on v-links?
>
> I looked at ccbootcamp answers and could not see any difference in my
> configs on ospf or serial lines.
>
> Reboot or clear ip ospf proc does not work either.
>
>
> GW
>
> MCSE (worthless) CCNP - the paper is nice I guess
> I have nothing cute to say.
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:27 GMT-3