From: fwells12 (fwells12@xxxxxxxxxxx)
Date: Wed Nov 28 2001 - 20:08:26 GMT-3
Throw OSPF on a router and add an interface to the OSPF process. Use the
commands on it. You can view the results with the output from 'show ip ospf
interface' This is a very good lesson if you have not done it before...
----- Original Message -----
From: "Bill Carter" <bcarter@family-net.net>
To: "Dane Clemons" <Dane.Clemons@waldec.com>; <ccielab@groupstudy.com>
Sent: Wednesday, November 28, 2001 2:20 PM
Subject: RE: CCBOOTCAMP LAB 20
> What does ip ospf point-to-point and ip ospf point-to-multipoint do???????
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Dane Clemons
> Sent: Wednesday, November 28, 2001 2:59 PM
> To: ccielab@groupstudy.com
> Subject: CCBOOTCAMP LAB 20
>
>
> Requirement of the lab states to change the hello interval on a OSPF
> interface
> without using the IP OSPF hello interval command. The IP OSPF dead
> interval
> command is used, will this command change the hello interval. I have
tried
> this
> command and it does not work. Maybe a code issue? Any advice would be
> appreciated.
>
> Thanks
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:24 GMT-3