From: vadim shayevich (vshayevich@xxxxxxxxxxx)
Date: Thu Nov 29 2001 - 12:58:46 GMT-3
It is the other way around:
RFC:
"This should be <RouterDeadInterval> some
multiple of the HelloInterval (say 4)".
Cisco:
ip ospf hello-interval
default: 10 sec
ip ospf dead-interval
default: Four times the interval set by the ip ospf hello-interval
command
In the LAB 20 solution, the task is accomplished by changing dead-interval,
which I think is incorrect and also tested to be incorrect.
----- Original Message -----
From: "Dennis #6" <vacant@home.com>
To: "Dane Clemons" <Dane.Clemons@waldec.com>; <ccielab@groupstudy.com>
Sent: Wednesday, November 28, 2001 3:25 PM
Subject: RE: CCBOOTCAMP LAB 20
> The dead interval is 4 times the hello interval... if I remember correctly
> changing the dead interval will automatically change the hello interval...
> are you verifying with sh ip ospf int?
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Dane Clemons
> Sent: Wednesday, November 28, 2001 3:59 PM
> To: ccielab@groupstudy.com
> Subject: CCBOOTCAMP LAB 20
>
>
> Requirement of the lab states to change the hello interval on a OSPF
> interface
> without using the IP OSPF hello interval command. The IP OSPF dead
> interval
> command is used, will this command change the hello interval. I have
tried
> this
> command and it does not work. Maybe a code issue? Any advice would be
> appreciated.
>
> Thanks
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:25 GMT-3