From: Waters, Kivas (UK72) (Kivas.Waters@xxxxxxxxxxxxx)
Date: Fri Nov 16 2001 - 14:55:25 GMT-3
Hi Bryan, I'm certainly no expert but might be able to add other solutions
to this problem. The following link does a good of of explaining the three
possible workarounds to the problem you are having:
http://www.cisco.com/warp/public/104/dcprob.html
regards
Ki
-----Original Message-----
From: Bryan Ginman [mailto:ginmanb@westnet.com]
Sent: 16 November 2001 16:44
To: CCIE
Subject: Dialer OSPF keeping the line quiet
Question for the dialer experts out there. I'm doing CCBootcamp lab 17
dialer section with DDR OSPF demand with callback. Here is a quick topology:
r6---isdn/ospf,area5----r5--frame/isis--r14---ospf/area10---r6
isdn ip's
r5 10.1.35.5 /30
r6 10.1.35.6 /30
This is just a snapshot of the full topology but there area that is causing
me problems. on R14 there is mutual redistribution between isis and ospf. I
have set up ospf demand circuit between r5 r6 etc, I cannot keep the line
quiet though because I keep getting 10.1.35.5 /32 added to r6 when the line
goes down causing the line to come back up. I set up a distribution list in
to deny either /32 address from both sides entering so that it does not get
added to the routing table. I had also tried putting ip ospf net p-p on the
interface that didn't work either. Any ideas
Thanks,
Bryan
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:17 GMT-3