Re: Basic Frame Relay, RIP, and Split Horizon Question

From: Adekola, Dennis D (Dennis.D.Adekola@xxxxxxxxxxxxxxxxxx)
Date: Sun Nov 04 2001 - 23:55:30 GMT-3

• Next message: Brad Ellis: "CCIE Security"
• Previous message: Chuck Church: "RE: NetBIOS_SSN_T"
• Maybe in reply to: Brad Caplan: "Basic Frame Relay, RIP, and Split Horizon Question"
• Next in thread: Chua, Parry: "RE: Basic Frame Relay, RIP, and Split Horizon Question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi Brad,

Can you ping between the routers serial interfaces?
If not then your problem will have to do with split horizon

Also are you sure the serial interfaces are clocked (DCE)

Dennis

bradcaplan@yahoo.com on 05/11/2001 02:11:00
To: ccielab
cc:
bcc: Dennis Adekola
Subject: Basic Frame Relay, RIP, and Split Horizon Question

Reply-To: bradcaplan@yahoo.com@INTERNET

I have a Hub and Spoke configuration setup as follows:

R1------FR-------R2
         |
         --------R3
         |
         --------R5
         |
         --------R6

All of the router's serial connections are in the
10.1.1.x/24 network. Each router's ethernet connection
is in a different class A network. Each router is
running RIP.

I can only ping the LAN interfaces of all
routers if I use point-to-point subinterfaces on the
spoke routers.

Is it possible to achieve this same connectivity
without using sub-interfaces? I tried using the 'no ip
split-horizon' command on the serial interface of the
hub router, (R1) but that does not seem to help.

Thanks,
Brad

• Next message: Brad Ellis: "CCIE Security"
• Previous message: Chuck Church: "RE: NetBIOS_SSN_T"
• Maybe in reply to: Brad Caplan: "Basic Frame Relay, RIP, and Split Horizon Question"
• Next in thread: Chua, Parry: "RE: Basic Frame Relay, RIP, and Split Horizon Question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:03 GMT-3