Basic Frame Relay, RIP, and Split Horizon Question

From: Brad Caplan (bradcaplan@xxxxxxxxx)
Date: Sun Nov 04 2001 - 22:57:04 GMT-3

   
I have a Hub and Spoke configuration setup as follows:

R1------FR-------R2
         |
         --------R3
         |
         --------R5
         |
         --------R6

All of the router's serial connections are in the
10.1.1.x/24 network. Each router's ethernet connection
is in a different class A network. Each router is
running RIP.

I can only ping the LAN interfaces of all
routers if I use point-to-point subinterfaces on the
spoke routers.

Is it possible to achieve this same connectivity
without using sub-interfaces? I tried using the 'no ip
split-horizon' command on the serial interface of the
hub router, (R1) but that does not seem to help.

Thanks,
Brad

This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:03 GMT-3