From: John.K.Feuerherd@xxxxxxxxxxxxxx
Date: Thu Oct 18 2001 - 22:06:08 GMT-3
I was working on lab 20 and I came across a problem. In the OSPF
section they stated that they wanted the Hello interval to be 10 seconds,
and I couldn't use the "IP OSPF Net" and "IP OSPF Hello-interval" commands
to accomplish this. Their configs show that you did this by setting the
Dead-interval to 40. I understand the philosophy of this, but I don't think
it works. I tried it and I got the following results:
interface Serial1.2 multipoint
ip address 155.10.10.5 255.255.255.240
ip ospf dead-interval 40
ip ospf priority 100
frame-relay map ip 155.10.10.1 102 broadcast
frame-relay map ip 155.10.10.3 103 broadcast
Serial1.2 is up, line protocol is up
Internet Address 155.10.10.5/28, Area 1
Process ID 1, Router ID 155.10.5.5, Network Type NON_BROADCAST, Cost: 64
Transmit Delay is 1 sec, State DR, Priority 100
Designated Router (ID) 155.10.5.5, Interface address 155.10.10.5
Backup Designated router (ID) 155.10.3.3, Interface address 155.10.10.3
Timer intervals configured, Hello 30, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:29
Am I missing something?
Thanks,
JF
John Feuerherd
Wells Fargo Bank
CCNP CCDP
1-505-766-6118 <- Office
1-505-301-1966 <- Cell
John.K.Feuerherd@Wellsfargo.com
MAC: Q2129-074
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:22 GMT-3