From: Tim Fletcher (tim@xxxxxxxxxxxxxx)
Date: Mon Oct 01 2001 - 20:33:41 GMT-3
I've tried it on one side only, and on both sides. It doesn't work either way.
I've also tried point-to-point and point-to-multipoint with no sucess.
-Tim
At 11:17 PM 10/1/01 +0100, Daniel Prinsloo wrote:
>Tim,
>
>have you tried applying it just to one end?
>
>If the router is part of a point-to-point topology, then only one end of the d
emand circuit must be configured with this command, but both sides must have th
is feature loaded.
>
>There is some discrepancy about multipoint, as some implementations specify th
at only the multipoint end must have the command, and other specify that all th
e routers in such a configuration requires this.
>
>I hope it helps.
>
>Tim Fletcher wrote:
>
>>Hi all,
>>I can't get OSPF demand-circuit to work right with dialer profiles. With a le
gacy DDR config it works fine. When I try to change it to dialer profiles, the
link keeps coming back up immediately after it goes down.
>>Any ideas what I'm doing wrong? Configs are below.
>>-Tim
>>Legacy DDR config (works):
>>interface Serial0/1:23
>> ip address 192.168.0.1 255.255.255.0
>> encapsulation ppp
>> ip ospf demand-circuit
>> dialer map ip 192.168.0.2 name R8 broadcast 5512101
>> dialer-group 1
>> isdn switch-type primary-ni
>> ppp authentication chap
>> ppp multilink
>>!
>>router ospf 1
>> log-adjacency-changes
>> network 192.168.0.0 0.0.0.255 area 0
>>!
>>dialer-list 1 protocol ip permit
>>
>>Dialer profiles config (keeps circuit up):
>>interface Serial0/1:23
>> no ip address
>> encapsulation ppp
>> dialer pool-member 1
>> isdn switch-type primary-ni
>> ppp authentication chap
>> ppp multilink
>>!
>>interface Dialer1
>> ip address 192.168.0.1 255.255.255.0
>> encapsulation ppp
>> ip ospf demand-circuit
>> dialer pool 1
>> dialer remote-name R8
>> dialer string 5512101
>> dialer-group 1
>> no peer neighbor-route
>> ppp multilink
>>!
>>router ospf 1
>> log-adjacency-changes
>> network 192.168.0.0 0.0.0.255 area 0
>>!
>>dialer-list 1 protocol ip permit
>>**Please read:http://www.groupstudy.com/list/posting.html
>--
>Daniel Prinsloo
>Prove IT
>daniel@prove-it.co.uk
>www.prove-it.co.uk
>ICQ 42743324
>Fax 0870 135 7712
>**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:11 GMT-3