From: Tony Olzak (tolzak@xxxxxxxxxxx)
Date: Thu Sep 13 2001 - 13:24:53 GMT-3
Another way is to load-balance with MHSRP. If you are using a platform
that supports multiple standby groups, you can set one router to be
master for one gatewayIP and the other to be the master for another. A
router or hosts on the inside can load-balance between these two
gateways.
If this is not possible, and you don't have enough interfaces to try the
crossover, this technique might work with two FastE's and a switch:
Use ISL on both interfaces and the switch to create trunks. Create a
separate transit VLAN and use a new subnetwork on subinterfaces to make
the routers communicate on the new virtual interfaces while at the same
time using HSRP on the other sub ints to do your redundancy.
Tony Olzak, CCIE #6689
ComWavz
tolzak@comwavz.com
-----Original Message-----
From: Bill Carter [mailto:bcarter@family-net.net]
Sent: Thursday, September 13, 2001 11:54 AM
To: McHie, Anthony; ccielab@groupstudy.com
Subject: RE: HSRP load sharing with redundant circuits
Run a crossover cable between the HSRP master and standby routers.
^-^-^-^-^-^-^-^-^-^-^
Bill Carter
CCIE 5022
^-^-^-^-^-^-^-^-^-^-^
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
McHie, Anthony
Sent: Thursday, September 13, 2001 10:07 AM
To: ccielab@groupstudy.com
Subject: HSRP load sharing with redundant circuits
Hey gang,
Here is my question:
How do you get an HSRP master to make use of the circuit on the HSRP
standby
router? The circuits are low bandwidth full-duplex. The desired state
is
to have both circuits utilized for both TX and RX. I'm open to
route-maps,
routing protocols, or any other means. Thanks
Current State
------------------
HSRP 10.3.0.3
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:16 GMT-3