From: Charles Manafa (charles.manafa@xxxxxxxxxxxxxxxx)
Date: Thu Sep 13 2001 - 12:24:25 GMT-3
HSRP routers will always use the path with the best metric, regardless of
whether it is via the master or standby router. Obviously, if both paths
have equal metric, then the routers may even load-balance egress traffic
across both paths.
CM
----- Original Message -----
From: McHie, Anthony <anthony.mchie@corp.bellsouth.net>
To: <ccielab@groupstudy.com>
Sent: Thursday, 13 September, 2001 17:07
Subject: HSRP load sharing with redundant circuits
> Hey gang,
>
> Here is my question:
> How do you get an HSRP master to make use of the circuit on the HSRP
standby
> router? The circuits are low bandwidth full-duplex. The desired state is
> to have both circuits utilized for both TX and RX. I'm open to
route-maps,
> routing protocols, or any other means. Thanks
>
> Current State
> ------------------
> HSRP 10.3.0.3
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:16 GMT-3