From: Kevin Williams (kevinwilli01@xxxxxxxxx)
Date: Mon Aug 27 2001 - 22:26:45 GMT-3
I have a hub and spoke frame relay network running
ospf. I am having problems getting the neighbors to be
fully adjacent with each other. The hub router becomes
full with each of the spokes and the spokes become
full with hub but I cannot get the spokes to become
full with each other. I have a "neighbor x.x.x.x"
command on the hub for each of the spokes and and I
have the same commands on the spokes for the hub and
the other spoke. When I do a show ip ospf neighbors on
the spokes I get the folling:
For the other spoke I get a Priority of 0 and State of
ATTEMPT/DROTHER. Is there something else that needs to
be done in order to get the two spokes to become
adjacent with each other?
I have the broadcast command at the end of my frame
relay map statements and I can ping from spoke to
spoke. I don't want to use the "ip ospf network
point-to-multipoint" or the "ip ospf network
broadcast" command.
Thanks for any help that you can give me.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:58 GMT-3