From: Rodgers Moore (rodgers@xxxxxxxxxxxxxx)
Date: Tue Jun 05 2001 - 22:43:23 GMT-3
If I remember correctly, this changes the ticks outgoing and not incoming, so
did you change it on the other router? What does "sh ipx ro" give you on the
other side?
Rodgers Moore
louie kouncar wrote:
> All,
>
> I am trying to change the default tick used on a bri0 interface, here is
> what I did:
>
> This was done by using the DELAY/ LINK-DELAY command under the BRI0
> interface...
>
> R2#sh ipx int bri0
> BRI0 is up, line protocol is up
> IPX address is 3.0001.0001.0001 [up]
> Delay of this IPX network, in ticks is 27 throughput 0 link delay 100
>
> As you can see, the ticks is 27....
>
> Now If I go to the routing table, I see that the default (Which is 7) has
> not changed:
>
> R2#sh ipx route
>
> C 1 (NOVELL-ETHER), Et0
> C 3 (PPP), BR0
> R 2 [07/01] via 3.0002.0002.0002, 37s, BR0
> R 4 [07/01] via 3.0002.0002.0002, 37s, BR0
>
> I tried clear IPX route *
> I also tried Shutting and no Shutting the interface with no luck..
>
> Can someone tell me what I can do to change this without using IPX
> IPXWAN????
>
> Thanks
>
> Louie J. Kouncar
> TCO3 Senior Data Center Engineer
> UUNET
> W-703-343-6645
> C-703-304-2460
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:18 GMT-3