ISDN TICKS QUESTION

From: louie kouncar (lkouncar@xxxxxx)
Date: Tue Jun 05 2001 - 19:18:21 GMT-3

• Next message: Roman Rodichev: "Re: OT: CCIE Certification"
• Previous message: Jason Bomar: "RE: Frame Relay Traffic Shaping"
• Next in thread: Rodgers Moore: "Re: ISDN TICKS QUESTION"
• Maybe reply: Rodgers Moore: "Re: ISDN TICKS QUESTION"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
All,

I am trying to change the default tick used on a bri0 interface, here is
what I did:

This was done by using the DELAY/ LINK-DELAY command under the BRI0
interface...

R2#sh ipx int bri0
BRI0 is up, line protocol is up
  IPX address is 3.0001.0001.0001 [up]
  Delay of this IPX network, in ticks is 27 throughput 0 link delay 100

As you can see, the ticks is 27....

Now If I go to the routing table, I see that the default (Which is 7) has
not changed:

R2#sh ipx route

C 1 (NOVELL-ETHER), Et0
C 3 (PPP), BR0
R 2 [07/01] via 3.0002.0002.0002, 37s, BR0
R 4 [07/01] via 3.0002.0002.0002, 37s, BR0

I tried clear IPX route *
I also tried Shutting and no Shutting the interface with no luck..

Can someone tell me what I can do to change this without using IPX
IPXWAN????

Thanks

Louie J. Kouncar
TCO3 Senior Data Center Engineer
UUNET
W-703-343-6645
C-703-304-2460
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Roman Rodichev: "Re: OT: CCIE Certification"
• Previous message: Jason Bomar: "RE: Frame Relay Traffic Shaping"
• Next in thread: Rodgers Moore: "Re: ISDN TICKS QUESTION"
• Maybe reply: Rodgers Moore: "Re: ISDN TICKS QUESTION"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:18 GMT-3