From: Erick B. (erickbe@xxxxxxxxx)
Date: Sun May 20 2001 - 15:36:48 GMT-3
I'm afraid there's no way to do it unless you use a
sub-interface and put that single DLCI on that
sub-interface only.
The backup command is looking at the interface status,
not the DLCI status. So if you have multiple DLCIs on
a interface and one of them is up the interface would
be up. In addition, using the frame relay end-to-end
keepalive feature (12.0(5)T) brings the backup link up
quicker and makes the backup more reliable then
without end-to-end keepalives.
Hope this helps. Erick
--- Theodore TZEVELEKIS
<theodore_tzevelekis@yahoo.com> wrote:
> Hi,
>
> How can one backup a single DLCI to a BRI.
>
> For example you have a serial with one or more
> dlci's
> configured. If the DLCI is killed from the other
> side, you
> want to back it up with the BRI. However, if you use
> the
> backup interface command on the main interface, as
> the
> latter does not go down (unless it is a subint, but
> I don't
> want to use subints), backup does not work.
>
> TO make myself clear: If the DLCI goes down, the
> main
> interface still stays up so backup does not work.
> I'm looking for a wat to backup on a per DLCI basis.
>
> Any ideas?
>
> Cheers,
> Theo
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:46 GMT-3