From: Martin, Chris (chris@xxxxxxxxxxxx)
Date: Wed May 17 2000 - 01:35:24 GMT-3
try it, let me know, i think the encap under the serial interface is
sufficient
----- Original Message -----
From: "Himawan Nugroho" <nhimawan@id.ibm.com>
To: "Martin, Chris" <chris@pacinter.net>; <ccielab@groupstudy.com>
Sent: Thursday, May 17, 2001 9:22 PM
Subject: Re: Frame Relay questions
>
> Chris,
>
> AFAIK, cisco router use LMI autosense to identify the LMI type in FR
> switch.
> And if we only type: encapsulation frame-relay, the default type is cisco
> and if we want to use IETF we have to type: encap frame ietf
>
> Are you sure we don't have to add cisco or ietf when using sub-interface?
> hmm..I have to try in my lab..
>
> Regards,
> Himawan Nugroho
> Network Solutions Specialist
> IBM Global Services - Indonesia
> Voice : 62-21-5238897, Fax : 62-21-2512933
>
>
> chris@pacinter.net (Martin, Chris)@groupstudy.com on 05/17/2000 10:34:30
AM
>
> Please respond to chris@pacinter.net (Martin, Chris)
>
> Sent by: nobody@groupstudy.com
>
>
> To: "Sam Pilot" <sam_pilot@hotmail.com>, <ccielab@groupstudy.com>
> cc:
> Subject: Re: Frame Relay questions
>
>
> Sam my comments are down below with a *** next to it
>
> ----- Original Message -----
> From: "Sam Pilot" <sam_pilot@hotmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Thursday, May 17, 2001 8:15 PM
> Subject: Frame Relay questions
>
>
> > Can someone explain the following questions to me
> >
> > 1) In serial interface config mode
> > encapsulation frame-relay cisco | ietf
> >
> > Is "ietf" used to connect to a non-cisco router
> *** YES thats what its for
> >
> > 2) frame-relay map ip X.X.X.X DLCINo broadcast cisco | ietf
> >
> > When would I use "ietf" or "cisco" in the map statement?
> > Is it related to the frame relay encapsulation type?
> *** yes it is related to the frame-relay type. However you wouldnt need to
> add the ciso or ietf statement if you configured subinterfaces. This
> command
> is really dependant if you are in a partial or full mesh cloud.
>
> Also if you specify frame-relay encap cisco or ietf you do not need to add
> those statements to your DLCI map statement above.
>
> HTH
> Chris Martin
> CCNP CCDP MCSE
> >
>
> >
> > Thanks
> >
> > Sam
> > **Please read:http://www.groupstudy.com/list/posting.html
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:44 GMT-3