From: Dean, Justin (Justin.Dean@xxxxxxxxxx)
Date: Fri May 11 2001 - 13:18:51 GMT-3
Has anyone done lab 19 yet? I had some trouble with the ATM/OSPF part. 1st
problem is that I could only get 1 of the routers to work with the
pvc-discovery. Just to make sure I am doing it right I created a "pvc 16 0
16 ilmi" on ATM2/0, then did "atm ilmi-pvc-discovery subinterface", did a
"show atm-vc" saw the pvc it discovered, then created a map-list and mapped
the remote ip address to the VCD of the discovered pvc, created interface
ATM2/0.2 multi (to match vcd 2 of the discovered pvc), and applied the
map-group and ip address. It worked fine on 1 router and did not on the
other. Any suggestions. I eventually just did a static pvc to make it work.
2nd problem. It says to put both atm routers in ospf without using any
neighbor statements. The interfaces are Non-Broadcast by default, so I added
"ip ospf network p-to-multi" on both routers and I could not get that to
work. I tried point-to-point and that didnt work. I eventually looked at the
answer configs and it shows point to multi, but if you look at the routing
tables it shows that it never worked....does anyone know if this is possible
to make these talk without any neighbor statements on multipoint interfaces?
Thanks,
Justin M. Dean, CCNP, CCDP
Network Engineer
NRT, Incorporated
(949)367-3438
justin.dean@nrtinc.com
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:39 GMT-3