ATM CLIP

From: Tariq Sharif (tariq_sharif@xxxxxxxxxxxxxx)
Date: Thu May 10 2001 - 08:22:11 GMT-3

• Next message: Tariq Sharif: "DLSw+ & ACL"
• Previous message: McCallum, Robert: "RE: Menus"
• Next in thread: Johnny Dedon: "Re: ATM CLIP"
• Maybe reply: Johnny Dedon: "Re: ATM CLIP"
• Maybe reply: Wayne Gustavus: "RE: ATM CLIP"
• Maybe reply: David Wolsefer: "RE: ATM CLIP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
When setting up ATM CLIP on a Cisco router connecting to a Cisco LS1010
switch is a full NSAP address required? I think only ESI is needed. Can
someone pls verify the following config.

interface ATM1/0
 ip address 200.200.200.201 255.255.255.0
 no ip directed-broadcast
 ip ospf network point-to-multipoint
 atm esi-address 000000000008.08
 no atm ilmi-keepalive
 atm arp-server self
 pvc signal 0/5 qsaal
 !
 pvc ilmi 0/16 ilmi
 !

Many thanks & regards.

Tariq Sharif

[GroupStudy.com removed an attachment of type application/ms-tnef which had a n
ame of winmail.dat]
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Tariq Sharif: "DLSw+ & ACL"
• Previous message: McCallum, Robert: "RE: Menus"
• Next in thread: Johnny Dedon: "Re: ATM CLIP"
• Maybe reply: Johnny Dedon: "Re: ATM CLIP"
• Maybe reply: Wayne Gustavus: "RE: ATM CLIP"
• Maybe reply: David Wolsefer: "RE: ATM CLIP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:38 GMT-3