From: David Wolsefer (dwolsefer@xxxxxxxx)
Date: Thu May 10 2001 - 13:38:50 GMT-3
As long as you have ILMI, then all you need is the esi. If you do not have
ILMI, then you need the full NSAP.
Regards,
David Wolsefer, CCIE #5858
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Tariq Sharif
Sent: Thursday, May 10, 2001 4:22 AM
To: Ccielab@Groupstudy. Com
Subject: ATM CLIP
When setting up ATM CLIP on a Cisco router connecting to a Cisco LS1010
switch is a full NSAP address required? I think only ESI is needed. Can
someone pls verify the following config.
interface ATM1/0
ip address 200.200.200.201 255.255.255.0
no ip directed-broadcast
ip ospf network point-to-multipoint
atm esi-address 000000000008.08
no atm ilmi-keepalive
atm arp-server self
pvc signal 0/5 qsaal
!
pvc ilmi 0/16 ilmi
!
Many thanks & regards.
Tariq Sharif
[GroupStudy.com removed an attachment of type application/ms-tnef which had
a name of winmail.dat]
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:38 GMT-3