From: Johnny Dedon (johnny.dedon@xxxxxxxxxx)
Date: Thu May 10 2001 - 13:24:21 GMT-3
TAriq,
You only need to specify the nsap address inlcuding the esi address on the
arp server client. Your config is for the server. You would need the full
nsap specified on the client pointing him to the server location.
ie atm arp-server nsap.esi.selectorbyte
with the esi matching the esi you configured on the arp-server.
HTH
Johnny Dedon
Senior Staff Consultant
Exodus Professional Services
johnny.dedon@exodus.net
www.exodus.net
----- Original Message -----
From: "Tariq Sharif" <tariq_sharif@btinternet.com>
To: "Ccielab@Groupstudy. Com" <ccielab@groupstudy.com>
Sent: Thursday, May 10, 2001 6:22 AM
Subject: ATM CLIP
> When setting up ATM CLIP on a Cisco router connecting to a Cisco LS1010
> switch is a full NSAP address required? I think only ESI is needed. Can
> someone pls verify the following config.
>
> interface ATM1/0
> ip address 200.200.200.201 255.255.255.0
> no ip directed-broadcast
> ip ospf network point-to-multipoint
> atm esi-address 000000000008.08
> no atm ilmi-keepalive
> atm arp-server self
> pvc signal 0/5 qsaal
> !
> pvc ilmi 0/16 ilmi
> !
>
> Many thanks & regards.
>
> Tariq Sharif
>
> [GroupStudy.com removed an attachment of type application/ms-tnef which
had a name of winmail.dat]
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:38 GMT-3