From: Erick B. (erickbe@xxxxxxxxx)
Date: Tue May 08 2001 - 05:43:15 GMT-3
Daniel,
Try reloading the router. I just set voice up to see
if I got the error and did and a reload corrected the
problem. 12.0(7)T and 12.1(5)T5 code...
Also, your dial-peer is configured as pots so I'm
guessing a IP target on a pots peer isn't going to do
much. What I noticed when I got the error was the
first time I set up the dial-peer it gave me pots,
voip, vofr as options but after I got the loopback
error it only gave me pots as a option for new
dial-peers until a reload.
Smells like a bug. This reminds of me a previous post
made awhile back by someone that couldn't get VoIP
working without having a loopback address configured.
If they removed the loopback address he got busy
signals. Don't know if he ever found out what was
going on... I just play with voice over and am not a
guru in it.
Erick
--- "Daniel C. Young" <danyoung99@mediaone.net> wrote:
> Folks,
>
> This is what I'm getting:
> r1(config)#dial-peer voice 1 pots
> r1(config-dial-peer)#session target ipv4:10.1.1.2
> Incorrect format for Session Target
> Must be of the form
> ^loopback:<compressed|uncompressed)$
>
> I'm running 12.0.7T on the 2620. The IOS image is
> c2600-js-mz.120-7.T.bin
> (enterprise plus, I believe).
>
> Any suggestions? Can't seem to locate this one on
> the cco.
>
> Daniel Young
> Sr. Network Engineer
> Internet Data Center
> SBC Service Inc. - ITO
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:36 GMT-3