"session target" command not working

From: Daniel C. Young (danyoung99@xxxxxxxxxxxx)
Date: Tue May 08 2001 - 02:20:43 GMT-3

Next message: Daryl Wan Wai Meng: "RE: "session target" command not working"
Previous message: Jaeheon Yoo: "How to inject a default route into ISIS level-1?"
Next in thread: Daryl Wan Wai Meng: "RE: "session target" command not working"
Maybe reply: Daryl Wan Wai Meng: "RE: "session target" command not working"
Maybe reply: Daniel C. Young: "RE: "session target" command not working"
Maybe reply: Rob Hopkins: "Re: "session target" command not working"
Maybe reply: Erick B.: "Re: "session target" command not working"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Folks,

This is what I'm getting:
r1(config)#dial-peer voice 1 pots
r1(config-dial-peer)#session target ipv4:10.1.1.2
Incorrect format for Session Target
Must be of the form ^loopback:<compressed|uncompressed)$

I'm running 12.0.7T on the 2620. The IOS image is c2600-js-mz.120-7.T.bin
(enterprise plus, I believe).

Any suggestions? Can't seem to locate this one on the cco.

Daniel Young
Sr. Network Engineer
Internet Data Center
SBC Service Inc. - ITO

(949) 221-1928 Office
(714) 350-8945 Cell
ICQ# 109846891
**Please read:http://www.groupstudy.com/list/posting.html

Next message: Daryl Wan Wai Meng: "RE: "session target" command not working"
Previous message: Jaeheon Yoo: "How to inject a default route into ISIS level-1?"
Next in thread: Daryl Wan Wai Meng: "RE: "session target" command not working"
Maybe reply: Daryl Wan Wai Meng: "RE: "session target" command not working"
Maybe reply: Daniel C. Young: "RE: "session target" command not working"
Maybe reply: Rob Hopkins: "Re: "session target" command not working"
Maybe reply: Erick B.: "Re: "session target" command not working"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:36 GMT-3