Re: "session target" command not working

From: Rob Hopkins (rshopkins@xxxxxxxxxxxxx)
Date: Tue May 08 2001 - 02:59:45 GMT-3

• Next message: Thomas Peroutka: "Re[2]: ntp poll interval"
• Previous message: Daniel C. Young: "RE: "session target" command not working"
• Maybe in reply to: Daniel C. Young: ""session target" command not working"
• Next in thread: Erick B.: "Re: "session target" command not working"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
use voip not pots, ie:

dial-peer voice 2 voip
  destination-pattern 3333
  session target ipv4:135.1.1.1
  ip precedence 5

Thanks,

Rob Hopkins

1.6180339887499
----- Original Message -----
From: "Daniel C. Young" <danyoung99@mediaone.net>
To: <ccielab@groupstudy.com>
Sent: Tuesday, May 08, 2001 1:20 AM
Subject: "session target" command not working

> Folks,
>
> This is what I'm getting:
> r1(config)#dial-peer voice 1 pots
> r1(config-dial-peer)#session target ipv4:10.1.1.2
> Incorrect format for Session Target
> Must be of the form ^loopback:<compressed|uncompressed)$
>
> I'm running 12.0.7T on the 2620. The IOS image is c2600-js-mz.120-7.T.bin
> (enterprise plus, I believe).
>
> Any suggestions? Can't seem to locate this one on the cco.
>
> Daniel Young
> Sr. Network Engineer
> Internet Data Center
> SBC Service Inc. - ITO
>
> (949) 221-1928 Office
> (714) 350-8945 Cell
> ICQ# 109846891
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Thomas Peroutka: "Re[2]: ntp poll interval"
• Previous message: Daniel C. Young: "RE: "session target" command not working"
• Maybe in reply to: Daniel C. Young: ""session target" command not working"
• Next in thread: Erick B.: "Re: "session target" command not working"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:36 GMT-3