RE: How to delete CAM entries marked 'Port Security Entry'

From: Haohong Lin (hhlin@xxxxxxxxxx)
Date: Fri May 04 2001 - 20:49:32 GMT-3

   
Hi,

    all the commands take no effect.

Cat5509> en

Enter password:
Cat5K> (enable) sh port sec 2/17

Port Security Secure-Src-Addr Last-Src-Addr Shutdown Trap IfIndex
----- -------- ----------------- ----------------- -------- -------- -------
 2/17 disabled No enabled 26
Cat5K> (enable) sh port stat 2/17
Port Name Status Vlan Level Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- --------- 

---
 2/17 R2522-250          connected  1          normal a-half  a-10
10/100BaseTX
Cat5K> (enable) clear cam stat 1
Static CAM entries cleared.
Cat5509> (enable) sh cam stat
* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
X = Port Security Entry

VLAN  Dest MAC/Route Des    [CoS]  Destination Ports or VCs / [Protocol
Type]
----  ------------------    -----  -----------------------------------------
--
1     00-08-ca-fe-ca-fe  X          2/17
1     00-10-7b-3a-26-ee  X          2/17
Total Matching CAM Entries Displayed = 2
Cat5K> (enable)

Regards,

Haohong Lin

-----Original Message-----
From: Rogell, Dennis [mailto:Dennis_Rogell@milgo.com]
Sent: 2001 05 04 22:28
To: 'Haohong Lin'
Subject: RE: How to delete CAM entries marked 'Port Security Entry'

If this is a cat 5000 try clear  cam static vlan id

Dennis Rogell
Email : dennis_rogell@milgo.com
Phone: (954) 846-5128

> -----Original Message-----
> From: Haohong Lin [SMTP:hhlin@szskzj.com]
> Sent: Friday, May 04, 2001 01:04
> To:   CCIELab
> Subject:      How to delete CAM entries marked 'Port Security Entry'
>
> Hi,
>
>     I can't delete some static entries in cam table, as show in following.
> I
> find no command corelatively via show conf all .
>     I have pressed "set arp" command before, which maybe results in such
> situation. After entered with "set arp ...", no commands are correlating
> with it in nvram config.
>
>     Any advice is  welcome, thanks in advance
>
> Cat5k> (enable) sh cam stat
> * = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
> X = Port Security Entry
>
> VLAN  Dest MAC/Route Des    [CoS]  Destination Ports or VCs / [Protocol
> Type]
> ----  ------------------    -----
> -----------------------------------------
> --
> 1     00-08-ca-fe-ca-fe  X          2/17
> 1     00-10-7b-3a-26-ee  X          2/17
> Total Matching CAM Entries Displayed = 2
> Cat5k> (enable)
>
>
>
> regards,
>
> Haohong Lin
> **Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:34 GMT-3