How to delete CAM entries marked 'Port Security Entry'

From: Haohong Lin (hhlin@xxxxxxxxxx)
Date: Fri May 04 2001 - 05:04:14 GMT-3

   
Hi,

    I can't delete some static entries in cam table, as show in following. I
find no command corelatively via show conf all .
    I have pressed "set arp" command before, which maybe results in such
situation. After entered with "set arp ...", no commands are correlating
with it in nvram config.

    Any advice is welcome, thanks in advance

Cat5k> (enable) sh cam stat
* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
X = Port Security Entry

VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol
Type]
---- ------------------ ----- ----------------------------------------- 

--
1     00-08-ca-fe-ca-fe  X          2/17
1     00-10-7b-3a-26-ee  X          2/17
Total Matching CAM Entries Displayed = 2
Cat5k> (enable)

regards,

Haohong Lin
**Please read:http://www.groupstudy.com/list/posting.html

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:33 GMT-3