From: tom cheung (tkc9789@xxxxxxxxxxx)
Date: Fri May 04 2001 - 08:53:01 GMT-3
set port security 2/17 disable
>From: "Haohong Lin" <hhlin@szskzj.com>
>Reply-To: "Haohong Lin" <hhlin@szskzj.com>
>To: "CCIELab" <ccielab@groupstudy.com>
>Subject: How to delete CAM entries marked 'Port Security Entry'
>Date: Fri, 4 May 2001 16:04:14 +0800
>
>Hi,
>
> I can't delete some static entries in cam table, as show in following.
>I
>find no command corelatively via show conf all .
> I have pressed "set arp" command before, which maybe results in such
>situation. After entered with "set arp ...", no commands are correlating
>with it in nvram config.
>
> Any advice is welcome, thanks in advance
>
>Cat5k> (enable) sh cam stat
>* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
>X = Port Security Entry
>
>VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol
>Type]
>---- ------------------ -----
>-----------------------------------------
>--
>1 00-08-ca-fe-ca-fe X 2/17
>1 00-10-7b-3a-26-ee X 2/17
>Total Matching CAM Entries Displayed = 2
>Cat5k> (enable)
>
>
>
>regards,
>
>Haohong Lin
>**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:34 GMT-3